WARNING !!! WARNING !!! WARNING !!!

DO NOT USE THIS FILE ON FULL WORKING MATRIX REVOLUTION CAM !!!

THIS IS NOT ORIGINAL DUMP OR " FOUNDED" FILE !!!

THIS FILE IS WRITEN BY ME AFTER TESTING 

MATRIX - ALL VERSION CAM.

IF YOU KILL YOUR MATRIX REVOLUTION WITH WRONG XILINX FILE " FOR RELOAD " , 

THEN TRY THIS FILE.

IF YOU KILL BRAND NEW WORKING REVOLUTION , DON'T BLAME ME !!!

USE AT YOUR OWN RISK !!!
--------------------------------------------------------------------------------------
File name : Rev_MLC2a.jed

THIS is same file like version 2 ,only it's compatibile with 3-th patry
Xilinx programmer.

This version support EMULATOR and SMART CARD

Here's second VERSION , TESTED WITH LATEST MRV217 FIRMWARE , KNOT CARD

AND WITH TOPFIELD STB. 

It's not yet finished.....new version is comming 

MLC

--------------------------------------------------------------------------------------
File name : Rev_MLC2.jed

This version support EMULATOR and SMART CARD

Here's second VERSION , TESTED WITH LATEST MRV217 FIRMWARE , KNOT CARD

AND WITH TOPFIELD STB. 

It's not yet finished.....new version is comming 

MLC

--------------------------------------------------------------------------------------

File name : Rev_MLC.jed

THIS IS FIRST ZERO VERSION , TESTED WITH LATEST MRV216 FIRMWARE AND WITH TOPFIELD STB.

IN THIS VERSION YOU CAN USE ONLY EMULATOR , 
NO SMART CARD SUPPORT UNTIL I COMPLETE FINISH ALL

--------------------------------------------------------------------------------------

How to repair : Easy load latest MRV216 ( bin ) firmware first , 
initialize Cam in STB and when you don't get picture on any of 
"emulator" chanel......Remove cam from STB and then load this Xilinx jed file.

Please NOTE : Xilinx chip inside Revolution is Read protected 
, so if youuse any other JTAG tool instead original Xilinx Impact 
programming software make shure that you erase ( overwrite ) read 
protection before write this file in Cam.If you don't have original 
Xilinx Impact programming software and programmer , 
you can use any of popular MM/MR JTAG programmers.
Also note that some of them is NOT capable to overwrite 
read protection so try to load file few time.

ANY FEEDBACK IS WELCOME

HAPPY NEW YEAR 

MLC

-----------------------------------------------------------------
DO NOT USE THIS FILE ON FULL WORKING MATRIX REVOLUTION CAM !!!

IF YOU KILL BRAND NEW WORKING REVOLUTION , DON'T BLAME ME !!!

REMEMBER !!! THIS IS NOT ORIGINAL FILE !!! USE AT YOUR OWN RISK !!!
-----------------------------------------------------------------



www.multiloadercard.com/mxc.html

----------------------------------
p.s. Please if you use this file on any sat boards , don't remove this
warning , becouse i don't want to be blamed if someone kill his cam.
Also i need feedback to complete this.